30 May 2012

Value Pack XXKQG Gingerbread 2.3.6 not an official one !


Samsung Galaxy S plus I9001 users can now update their devices with the value pack namely Value Pack XXKQG Gingerbread 2.3.6 Firmware Update. Over a period of article, we would be checking out a tutorial to apply this update.
This update is not an official one !

Important: We and even the developer won’t be responsible for any damage that takes place to your device while following these steps.

How to Update Galaxy S Plus I9001 with Value Pack XXKQG Gingerbread 2.3.6 Firmware Update
  • Grab the XXKQG Firmware Package from here to your Computer. And extract it. Next, download Odin and after that open it in your computer.
  • Now you need to enter your device into download mode which can be entered by pressing and holding Volume Down key + Center + Power button till the time you see a green robot on your phone confirming that you entered into download mode.
  • Make sure you have Opened Odin in your computer.
  • Now connect your phone to computer while ensuring Odin is open in your computer.
  • As soon as you connect your phone to the computer, the ID: COM section in Odin will turn Yellow.
  • Click on ‘PDA’ to select the“I9001XXKQG_I9001XXKPL_I9001NEELE1_HOME.tar.md5”  file which can be found from the extracted folder and then finally click on ‘Start’ button present in Odin to start the process of firmware update.
  • The process would take few minutes to complete. After it is done, the phone will reboot on its own and after you see the home screen on your device, disconnect your phone by removing the USB cable.
  • Now turn off your phone and enter it into recovery mode by pressing a combination of these buttons: Volume Up + Center + Power button.
  • In recovery mode, select ‘wipe data/factory reset’ and ‘wipe cache partition’ so that you can clear the cache.  Now select ‘Go back’ and then reboot system now to restart your phone into normal mode.
  • And you have successfully rooted your device.

Or use Flashing ROMs & Guides-Root page


If you have connection problems with Odin3-v1.838 then use special for i9001 ,Odin 4.43 (multidownloader)


Important things :

1.Must have all the drivers of the phone installed on Pc (from Kies)
2.Connect to the main usb port !
3.Read each step carefully

4 comments:

Gaurav Singla said...

I am trying to upgrade my firmware but its gets stuck at setup connection in Odin3.
As mentioned in steps i put my phone in debug mode and then followed all the steps.

Please help.

Demian Sorin said...

What usb port are you using?
You have to use the main port from the back of Pc !

Demian Sorin said...

Read the Flash guide page ,and please leave a comment if u finish to flash .

Demian Sorin said...

important things
1.Must have all the drivers of the phone installed on Pc (from Kies)
2.Connect to the main usb port !
3.Read each step carefully